EX 120 Moto

EX 120 Moto

For small engines and motor equipment

Revitalizant EX120 MOTO is designed for repair, restoration and antiwear protection of engines of motor equipment with combined or separate lubricating system with capacity up to 1,000 cm³.

Applied to motorcycles, motorbikes, snowmobiles, personal watercrafts and household motor equipment, lawnmowers, chain saws etc. Due to its by 20% greater* active agent's concentration, Extreme Action 120% (EX120) Revitalizant possesses the extended potential of worn surface restoration and antiwear protection.

* Compared to XADO Gel-Revitalizant for small engines and motor equipment

Application

Application instructions for engines with combined lubricating system:

1. Introduce** the contents of the syringe* into the fuel tank before fuelling.
2. Fill the tank with fuel.
3. Start the engine and let it idle for 2-3 min.
4. Operate the engine in normal operational mode.

Application instructions for engines with separate lubricating system:

1. Warm up the engine to the normal operating temperature.
2. Empty the contents of the syringe into the oil filler neck.
3. Start the engine and let it idle for 2-3 min.
4. Operate the engine in normal operational mode.

* Compared to XADO Gel-Revitalizant for small engines and motor equipment

** It is recommended preliminary to dissolve the contents of the syringe in a small amount of oil (20-30 ml) at its temperature of exceeding +20°C.

Note

The compound is equally effective for application in two- and four-stroke internal combustion engines of all brands. Does not influence the wet clutch operation. It is not recommended to change oil in four-stroke internal combustion engines until the end of treatment. The treatment is considered complete after not less than 1,500 km or 20 hours of engine operation. If the engine capacity exceeds 1,000 cm³ it is necessary to double the dosage. The revitalizant is compatible with any additives, metal conditioners, remetalizants irrespectively of its application sequence. A protective ceramic-metal coating is formed on the metal surface of any alloys. If the wear rate is close to 100%, destroyed parts should be replaced.

Syringe 4 ml (Art. XA 10037)

  • Restores worn surface of engine cylinders, eliminates scuffs and scratches
  • Increases and levels compression in cylinders
  • Protects friction parts against wear
  • Considerably reduces fuel consumption
  • Restores engine capacity up to factory values
  • Increases service life of an engine by 3 times
  • Decreases the level of toxic components in exhaust gases
  • Decreases noise and vibration level
  Bad            Good
captcha ->