Gel-Revitalizant for Small Engines

Gel-Revitalizant for Small Engines

Gel-Revitalizant for Small Engines is designed for restoring repair and wear-out protection of engine parts with volume up to 61 in3 with combined or separate fuel system. 

Can be applied to motor bikes, motor cycles, wave runners and consumer electronics (grass mowers, chain saws, engine grinders, perforators, drills etc.).

Ensures triple effect – repair, protection and savings.

General characteristics of the cermet coating:

  • Microhardness – 750 kg/mm2;
  • High corrosion resistance;
  • Roughness Ra up to 0,06 mkm.

Treatment procedure for small engines with combined fuel and oil system

Step 1: 

  • Squeeze out the content of one sachet into the full fuel tank (it is recommended first to dissolve the content of the sachet in the oil or fuel at temperatures above 20ºC).
  • Start the engine and let it idle run for not less than 2 min.
  • Run in a regular mode

Step 2: 

  • Repeat  Step 1 when refilling the fuel tank.

Step 3: 

  • Repeat Step 2.

Treatment procedure for small engines with separate fuel and oil system

Step 1: 

  • Warm up the engine to the work temperature.
  • Squeeze out the content of one sachet into the filler of the oil tank.
  • Start the engine and let it idle run for not less than 2 min.
  • Run in a regular mode.

Step 2: 

  • Repeat Step 1 after  150-250 km run of a motorcycle or 4 hours of engine operation (equivalent is 200-250 km)

Step 3: 

  • Repeat once again  Step 1 after 150-250 km run of a motorcycle or 4 hours of engine operation (equivalent is 200-250 km)

Note!

  • The compound is equally effective for any two- and four-cycle engines of any kind.
  • The processing is considered to be completed after no less than 1500 km or 20 hours of engine operation. It is not necessary to change oil in four-cycle engines before the processing.
  • Double the dose if the volume of the engine is more than 1000 cm3.
  • XADO Revitalizant is comparable with any additives, dopes, metal conditioners, remetallizants etc. regardless of sequence of its application.
  • The protective cermet coating is formed on the metal surfaces made of any alloys. If the wear-out of the surface is about 100% the worn parts should be replaced.

Package:

Package 4.5 ml (XA 10009)

  • Restores cylinders, eliminates scratches and microcracks;
  • Increases compression in cylinders;
  • Protects friction parts from wear-out;
  • Reduces fuel consumption;
  • Increases engine power up to 100%;
  • Extends engine life up to 3 times;
  • Reduces harmful emissions;
  • Decreases the level of noise and vibration.
  Bad            Good
captcha ->